Cheers for that Manny. Lesson learned. Bleedin road riders eh!
I just can't believe it happened so quick as i was just wobbling round trying to run it in. I didn't even get air bourne and I love jumping.

Aye..it's always best to go a little slack than tight, a slack chain will just wear out the sprockets faster..unless it's so slack it jumps the sprocket and cannons a hole in your engine casing which is not good!!

Anyone got any news on the goggles? I have two sets and neither came with instructions

What the rolloff googles?? Stick them over your eyes! nah every time the film strip gets dirty you pull the little cord on the left hand side a couple of times which feeds a new clean strip across.

Ah but Manny that's the bit i got Mine dont roll off as i found out on a very muddy MX track I have now after a little investigation found the rolls of tape but what do i do with them??? Anyone had to put a refill in these? That might help

Oh boy that is hard one to explain..I'll give it a shot.

You need to keep the old spent spindle and put it in the pull cord side with the slot engaged in the bottom cam.

Put the new film on the left hand side as your facing it, undo the sticky tab that holds the film together but leave it still attached to the film.

Feed it across the googles, you can now put that side cover back on.
Wrap the sticky bit around the spindle going around the back first. Stick the cover on give it a few pulls to tighten everything up...

Any good! sounds like a load of shit to me!!